HomeWMZWork piecesGear shafts
Werkzeugmaschinenbau Ziegenhain GmbH

T +49 6691 9461 0

contact us
Gearbox
Workpieces Gearbox

WMZ offers a wide range of manufacturing solutions for shafts - from end machining to complete machining. We can apply technologies from turning, drilling, milling to deep hole drilling, skiving and gear hobbing. Our individual modular system allows almost any machine configuration for this purpose.

Truck transmission shaft

Machining of truck transmission shafts with an internal and external spline in one clamping with skiving.

Manufactured on: WMZ V300

Factsheet.pdf

Truck transmission shaft

Complete machining of truck transmission shafts in two setups with center drive including deep hole drilling >500mm.

Manufactured on: WMZ V300

Factsheet.pdf

Gear shaft

End machining of a gear shaft with center drive in only 21 seconds.

Manufactured on: WMZ V300

Factsheet.pdf

Gear shaft

Complete machining of gear shafts in two setups with classical end machining with driven tools.

Manufactured on: WMZ V300, H200

Factsheet.pdf

Gear shaft

Complete machining of gear shafts in two setups with classical end machining with driven tools.

Manufactured on: WMZ V300, H200

Factsheet.pdf

Synchroniser rings

Complete machining of synchroniser rings from 6m tubes at a cycle time of 5 seconds per workpiece.

Manufactured on: WMZ V300

Factsheet.pdf

Gear shaft

End machining of gear shafts in center drive including simultaneous deep hole drilling on both sides.

Manufactured on: WMZ V300, H200

Factsheet.pdf

Share page